Client Properties (Workstation Client Settings)

Use this tab to configure the Workstation Backup Client Console capabilities and settings.

Override Global Settings

Select this option to specify Workstation Backup Client Console capabilities and settings for this client.

Note that this configuration will only affect the Workstation Backup Client Console for this client, and will override the global Workstation Backup Client Console settings configured from the Control Panel - Replication Settings.

Allow Backup Control

Specifies if backup jobs can be executed from the client console.

Show Recovery Page

Specifies if restore jobs can be executed from the client console.

Show Scheduling Page

Specifies if backup jobs can be scheduled from the client console.

Allow Content Management

Specifies if the content for backup can be managed from the client console.

Allow compare data before backup

Specifies if optimized full and optimized incremental backups can be executed from the client console.

Allow to change smart scheduling parameters

Specifies if the smart scheduling can be managed from the client console.

Allow to run data verification jobs

Specifies if the data verification report can be generated from the client console.

Allow to generate data verification report at the end of backup jobs

Specifies if the data verification report at the end of backup jobs can be generated from the client console.

Show alters to users if ... successive jobs failed

Specify the number of successive backup job failures, after which the client is alerted. Default value is set to 5.

Minimum bandwidth before a backup can be attempted (KB)

Specify the minimum bandwidth required for the client to attempt a backup job. Jobs go into Suspended state when the minimum bandwidth is not available, and Resume when the required bandwidth becomes available. Default value is set to 128 KB.

Journal Chunk size (KB)

Specifies the chunk size of the journal  files created in the client. The default value is set to 1024 KB.