Automatic Registration - Install Custom Package

The following section describes the steps involved in deploying the Custom install package to the desired client computers.

Once the installation packages are deployed, the client computers will automatically register to the designated target CommServes.

  • Firewall on the target CommServe computer needs to be disabled while installing this Custom Package on the client computer.
  • Make sure that the CommCell Authentication is disabled on the target CommServe.

Install the Custom Package - Windows

Install the Custom Package - Linux

Install the Custom Package - Macintosh

Install the Custom Package - Windows

Use the following procedure to install using the custom package self extracting file:

  1. Locate the custom package and double-click the .exe file to start the installation.

    For example:

    For a Windows X64 system using default paths, this file can be located at  C:\CustomPackageName\CustomPackageName_WinX64

  2. Click  Next to continue.

  3. Provide a path for the installer to extract the installation package.

  4. The installation proceeds silently. This may take several minutes to complete.

  5. Click Finish.

Install the Custom Package - Linux

Use the following procedure to install using the custom package self extracting file.

  1. Navigate to the location specified during Custom Package creation.

    For example:

    /opt/UnixCustomPackage/pkg

  2.  Run ./silent_install -p default.

    For example:

    <client_computer>/opt/UnixCustomPackage# ./silent_install -p default

    Performing non-interactive Install of the following modules...
    * Base Client [1002] [CVGxBase]
    * Base0 Client [1003] [CVGxBase0]
    * UNIX File System iDataAgent [1101] [CVGxIDA]
    Install of the above modules completed successfully.

Install the Custom Package - Macintosh

Use the following procedure to install using the custom package self extracting file.

  1. Navigate to the location of the saved file specified during Custom Package creation.

    Double-click the file to extract it.

  2. Double-click the extracted file to start the installation.
  3. Click Continue.
  4. Select the language of your choice and click Continue

  5. Click Agree to accept.

    Click Continue.

  6. Select a destination to install the software.

    Click Continue.

  7. To change the location of the install, click Change Install Location.

    To proceed, click Install.

  8. Click Close to complete the software installation.