EnableSystemState

Scope

Intended Audience
All X
CommVault Internal  
CE/System Test  
Development  

Platform

  • CommServer (Database: CommServ)

Release

  • 10.0.0

Description

Script to enable system state on all default subclietns across the commserve.


This script can take client name and backup set name as input.(Both are optional.)


If both are given the default subclient under system state backup is enabled on the given client and backupset and disabled on all its peer subclients. If only the client name is given then the same is done on all active backupsets under the client. When 'allclients' is used the system state is enabled all default subclients across the CS.


Usage

qoperation execscript -sn EnableSystemState -si allclients/c=clientName -si backupsetname


  • script_name : EnableSystemState
     
  • Version


  •  
  • Disclaimer of Warranties

    CommVault provides software tools and utilities on an "as is" basis, as a courtesy and convenience to its users, and they may be changed from time to time without notice. These tools and utilities are provided without express, implied, or statutory warranties of any kind. You assume full risk and responsibility for the selection, possession, performance and proper installation and use of the software tools and utilities, and for verifying the results obtained there from. Your use of CommVault software tools and utilities indicates your unconditional acceptance of the above disclaimer.