LMCreateDefaultMonitoringPolicy

Scope

Intended Audience
All X
CommVault Internal  
CE/System Test  
Development  

Platform

  • CommServer (Database: CommServ)

Release

  • CVSOFTVERSION

Description

- The script can be used to create default monitoring policy.


- Following conditions are checked while creating default monitoring policy.


- 1) If the default monitoring policy is already created,then do nothing.


- 2) The default monitoring policy will be created with disabled state.


- 3) If the analytic engine is configured already,then analytical engine will be associated to the default monitoring policy.


- 4) Default monitoring policy cannot be enabled unless analytical engine is configured.


Usage

  • qoperation execscript -sn QS_CreateLMDefaultMonitoringPolicy
     
  • -
     
  • - The script can be used to create default monitoring policy.
     
  • - The default monitoring policy will be created with disabled state.
     
  • - If the analytic engine is configured already,then analytical engine will be associated to the default monitoring policy.
     
  • - Default monitoring policy cannot be enabled unless analytical engine is configured.
     
  • Version


  •  
  • Disclaimer of Warranties

    CommVault provides software tools and utilities on an "as is" basis, as a courtesy and convenience to its users, and they may be changed from time to time without notice. These tools and utilities are provided without express, implied, or statutory warranties of any kind. You assume full risk and responsibility for the selection, possession, performance and proper installation and use of the software tools and utilities, and for verifying the results obtained there from. Your use of CommVault software tools and utilities indicates your unconditional acceptance of the above disclaimer.