ToggleMountPathsofDDBMA

Scope

Intended Audience
All X
CommVault Internal  
CE/System Test  
Development  

Platform

  • CommServer (Database: CommServ)

Release

  • 10.0.0

Description

This script takes as parameter 1. enable (1 or 0) and a DDBMA Name(say test-ma) .


The script will then Enable/ Disable the mount paths attached to the SIDBStores of the test-ma .


By attached mounts paths we mean the mount paths onto which the backups from the store's deduped storage policy get stored.


If input param enable = 1 , then mount paths are enabled. if enable = 0, mount paths are disabled.


Usage

  • qoperation execscript -sn ToggleMountPathsofDDBMA [-si @enable = 1] [-si @MAName = 'test-MA']
     
  • Options: @enable : @enable = 1 : enable the mount paths ; @enable = 0 : disable the mount paths
     
  • Version


  •  
  • Disclaimer of Warranties

    CommVault provides software tools and utilities on an "as is" basis, as a courtesy and convenience to its users, and they may be changed from time to time without notice. These tools and utilities are provided without express, implied, or statutory warranties of any kind. You assume full risk and responsibility for the selection, possession, performance and proper installation and use of the software tools and utilities, and for verifying the results obtained there from. Your use of CommVault software tools and utilities indicates your unconditional acceptance of the above disclaimer.