Advanced Client Properties (General)

Use this dialog box to configure the following properties for a client:

Enable SnapProtect

Select this check box to enable the SnapProtect for the client. Once you enable the SnapProtect, you can configure a subclient for SnapProtect backup.

Enable Retry on network errors

When enabled, this option allows you to set the retry options in case of network errors.

  • Retry Frequency (seconds)

    The interval (in seconds) at which the Job Manager will continuously check for network connectivity.

  • Retry Count

    The number of times the Job Manager will check for network connectivity.

CDR Log File Location

Type the path or click Browse to specify the location of the Continuous Data Replicator (CDR) log files and how often the logs must be replayed. CDR performs replication by logging all activities in the source computer and replaying the log in the destination computer.

Enter Alternate Cache Partition for QSnap. Please ensure that the volume specified is an NTFS volume.

Use this space to change the location of the QSnap Copy-on-Write (COW) cache for all volumes on the client.

  • Specify the drive letter without a slash. For example, type F: to use drive F as the alternate cache location. Mount paths are not supported.
  • For Windows platforms, you can only specify an NTFS volume as a cache volume.

Exclude from SLA and Strike Counts

When enabled, the client is excluded from the SLA (Service Level Agreement) calculation and the Client Strike calculation for the Worldwide Dashboard, CommCell Dashboard, SLA Report, and Client Strike Count Report. When disabled, the client is included in these calculations.