Setting the Active Node for CommServe Failover

Verify and set the active node for CommServe failover manually.

Before You Begin

Make sure the same and latest service pack is installed on production and standby CommServe hosts.

About This Task

For initial set up, set the active node to production CommServe host.

For subsequent CommServe failover operations, you can set the active node to either production or standby CommServe host as required.

Make sure to provide a minimum of 1 minute time interval between subsequent failover operations.

Procedure

Change the active node to the production or standby CommServe host as required.

cvfailover [<node number>]

For node number use 1 for production or 2 for standby CommServe host.