SetAllDrives

Description

This program disables or enables all the drives for SnapProtect.

Usage

  1. Copy the executable to software_installation_directory\Base.
  2. Open a command window, change the directory to software_installation_directory\Base, and run SetAllDrives using the following syntax:

    SetAllDrives [-vm virtual machine name] disable|enable

    If the drives are successfully set to the desired mode, notification will be given indicating the state that the drives were set to. If there are any errors, an appropriate message will be printed.

    The Event Viewer will not show an event indicating that the drives were reset if done using this utility.