SnapProtect for VMware – Fujitsu ETERNUS DX
|Overview||Deployment||Configuration||Automatic Discovery||Select Storage Array||Backup||Vault or Mirror Copy||Backup Copy||Restore|
- Local Copy license for Snap and Clone
- Thin Provisioning license
On the client and proxy computers:
- Create a Host Affinity group for the proxy computer
On the Fujitsu ETERNUS DX array, ensure the following:
- All members are running firmware version V10L22-1000 or higher
- SMI-S is enabled
- SDV and SDPV volumes are created if you are using SnapOPC
Configure Destination Volumes
- Forbid Advanced Copy and Encrypted volumes are not supported.
- Depending on the type of snapshot being used, review the following for the creation of destination volumes:
For Snap Snapshots
Specify a volume label via Volume Label Prefix array configuration. SnapOPC snapshots use any suitable SDV having name matching the label set through array config. If there are no suitable SDV available with the special name, the backup job will fail.
If you need to create a new SDV volume, ensure that the SDV volume is of equal size to the source volume. Make sure to keep volume name matching to volume label set through array configuration.
For example : if array config Volume Label Prefix is set as “iSnap_”. SDVs names qualifying this label are iSnap _01, iSnap _02, and iSnap _SDV15 etc.
For Clone Snapshots
Preference is given to target volumes with a special name set by via Volume Label Prefix array configuration. If there are no suitable volumes with the special name, the backup job will fail. If there are more than one volumes with the special name, preference will be based on the source volume type. If source volume is a standard volume, preference will be given to standard volumes otherwise thin provisioning volume.
If array configuration Volume Label Prefix is not specified, destination volumes are automatically created for clone snapshots. If a non-existing device group is specified during array configuration in the CommCell Console, a destination volume is created based on the source volume type. However, if a valid device group is specified, the following destination volumes are created depending on the device group type:
- A Thin Provisioning volume is created if the device group is a Thin Provisioning pool.
- A standalone volume is created if the device group is a RAID group.
Set Up the Array Information
Provide the identification information for the array to ensure access.
The following section provides step-by-step instructions for setting up the array information.
- From the CommCell Browser, click the Storage tab and then click the Array Management icon.
- In the Array Management dialog box, click Add.
Select Fujitsu ETERNUS DX from the Snap Vendor list.
Specify the CM IP Address of the array in the Name field.
For reference purposes, the screenshot given below shows the CM IP Address for the Fujitsu storage device.
- Enter the CM IP Address of the array in the Control Host field.
Click Change and enter the access information of a user with administrative privileges in the Username and Password fields in Enter User Name and Password dialog box.
User should have Storage Admin or Maintainer / Admin roles.
Use the Description field to enter a description about the entity. This description can include information about the entity's content, cautionary notes, etc.
Click OK to save the information.
- Click the Snap Configuration tab and configure the following:
Storage Device Group: Specify the name of the of the RAID group or Thin Provisioning group created on the array to be used for clone operations.Use Devices only from this Group: Select this option to use the snapshots devices available in the storage pool specified in Storage Device Group.