Loading...

Limiting the Number of Simultaneous Jobs from the Command Line Interface

You can limit the number of simultaneous data and log backup jobs that run on a client.

Procedure

  1. Use the qlogin command to log onto the CommServe.
  2. On the command line, go to software_installation_directory/Base and type one of the following commands:
    • Limit the number of simultaneous data backup jobs:

      qoperation execscript -sn SetLimitRunningJobs -si 'client'|'Oracle_RAC_pseudo_client_name' -si 'DataCount' -si limit

      where limit is the number of data backup jobs that are allowed to run simultaneously.

    • Limit the number of simultaneous log backup jobs (if a job contains both data and logs the job is not limited):

      qoperation execscript -sn SetLimitRunningJobs -si 'client'|'Oracle_RAC_pseudo_client_name' -si 'LogCount' -si limit

      where limit is the number of log backup jobs that are allowed to run simultaneously.

  3. Run the qlogout command to log off the CommServe computer.