Loading...

sealAllActiveStores

Scope

Intended Audience
All X
CommVault Internal  
CE/System Test  
Development  

Platform

  • CommServer (Database: CommServ)

Release

  • 11.0.0

Description

To seal all active stores on a Commserver, use the following command:



qoperation execscript -sn sealallactivestores



WARNING - performing this will seal all stores and create new ones. This will cause new base lines to occur in all storage policy copies using deduplication which could lead to a lot of extra network traffic and media usage. Do not run this script without knowing the reason why you would want to seal all stores.


Usage

  • qoperation execscript -sn QS_sealAllActiveStores
     
  • Version


  •  
  • Disclaimer of Warranties

    CommVault provides software tools and utilities on an "as is" basis, as a courtesy and convenience to its users, and they may be changed from time to time without notice. These tools and utilities are provided without express, implied, or statutory warranties of any kind. You assume full risk and responsibility for the selection, possession, performance and proper installation and use of the software tools and utilities, and for verifying the results obtained there from. Your use of CommVault software tools and utilities indicates your unconditional acceptance of the above disclaimer.