Loading...

Configuring ACFS Mount Points as File System Subclient Content

You can configure ACFS mount points as your subclient content.

Before You Begin

Procedure

  1. From the CommCell Browser, navigate to Client Computers > client > File System.
  2. Right-click the backup_set, point to All Tasks, and then click New Subclient.

    The Create New Subclient dialog box is displayed.

  3. On the General tab, in the Subclient Name box, type the name for the subclient.
  4. On the Content tab, add the path to the ACFS mount point.
    1. Click Add Paths.
    2. In the Add Paths dialog box, type the path to the ACFS mount point.
    3. Click OK.
  5. Optional: On the Pre/Post-Processing tab, type the path to the pre-process script or post-process script.
    1. In the PreBackup Command box, type the full path name for the script.
    2. In the PostBackup Command box, type the full path name for the script.
    3. To run the post-backup process regardless of the job's outcome, select the Run Post Backup Process for all attempts check box.
  6. On the Storage Device tab, in the Storage Policy list, click a storage policy name to associate with the subclient.

    Tip: To create a new storage policy, click Create Storage Policy and follow the instructions in the storage policy creation wizard. 

    For information on storage policy creation, see Storage Policy - Getting Started.

  7. Click OK to close the Create New Subclient dialog box.